Electric back door installation method basic operation method
・Open the tailgate.
push the trunk door
On the key remote control, press and hold the unlock button for 3 seconds.
Press the driver's trunk button.
・Close the tailgate.
Press the add tailgate button.
On the key remote control, press and hold the unlock button for 3 seconds.
Push the driver's seat and trunk button.
1. How to adjust height
Adjust the tailgate to the appropriate height and press and hold the tail button for 5 seconds.
You will hear a long beep when the setup is complete.
When you open it again, it will open to the set height.
2. Speed adjustment
There are five opening and closing speeds for the tailgate, with the default being 4 and the fastest gear being 6.
The setting method is to press and hold the tailgate button, and when you hear the buzzer twice in a row, it means that the speed is set to 2.
If you hear the buzzer 3 times in a row, it means the speed is set to 3.
After installation is completed, matching operation is required when the decoder is connected.
Adjust the electric tailgate to its highest position, press and hold the tailgate button for 5 seconds, and release the button when you hear a long beep.
This completes the initial setup.
①This time, we will take this as an example.
②Remove the instrument panel inside the trunk.
③Remove the back gate instrument panel as well.
④Remove the trunk rod.
⑤Remove the genuine ball joint and install the included ball joint.
⑥Attach the electric back door rod.
⑦Drill a 20mm hole using the included hole drill.
⑧Attach the wiring as shown in the diagram.
⑨Remove the genuine lock and attach it with the included lock.
⑩The diagram shows the location of the suction lock.
⑪The figure shows the wiring layout.
⑫ There is no need to connect any wiring to the lock block.
Remove the plug and attach it to the electric back door plug.
⑬Remove the passenger seat instrument panel and find the wiring shown in the diagram.
⑭Attach the ground wire.
⑮ Find the use box and install it to the fuse box.
⑯Attach the control box to the back of the tailgate.
⑰ The figure is a schematic diagram of the trunk gate button.
⑱Make a 20mm hole in the location shown in the diagram on the driver's seat and attach the button.
⑲The wiring shown in the diagram shows that there is no need to open it manually.
⑳Wiring installation diagram
㉑ Routing the power cable.
㉒Wiring layout diagram.
Even if the car model is different, the basic installation method is the same.
We also provide installation support, so please feel free to contact us.
importparts.zeroone@gmail.com
Electric back door specialty store IMP
https://importparts-zeroone-powerbackdoor.myshopify.com/
#Electric back door #Power back door #Installation method #Manual for contractors #Setting method #Import parts zero one